|
work support extensions ineffective, etc. Purchasing 2 additional stops allows support tor the work over its entire length and allows me to make repitive cuts of different lengths without moving the stops. have the Dewalt 708 Sliding mitre & stand which goes with these stops. It is a simple matter to flip up the stop and convert a support into a stop to make a precise repetitive cut. The current stand is very well designed and I recommend it. Note I had the older stand which has a sliding board and it did not work nearly as well as the one which works with these stops for a variety of reasons including sliding board jam due to sawdust, legs do not fold compactly.
When I purchased my DeWalt workstation these came with the unit. If you think you will need them, chances are you don't know how much you are missing them, and how much time they will save you. I have used them and they work very well.
I got it for the dewalt miter saw workstation to support long trim. Works great.
These are great to have at the very least three. I always said I was going to get a couple more and now I have. Great product, great price. Glad it got run over, so I had to get the extras I wanted anyway. I had the saw table run over by a customer and damaged one of the supports. I keep two on each side of the saw. It's the best part of the saw.I am a kitchen and bath remodeler and use this every day for about 4/5 years and never had a problem, only the ladies car did. one at the end of the extension and one at the end of the bench.
In my opion you will realry need more than 3-4 on the stand at once. They are full adjustable to match the tool in use. These are great to get a coupl extra supports. But you only need so many on the stand at one time. And the stand comes with two. So either you can adjust a few of them everytime you switch tools, or get enough to have a few for each tool.
|
May be eligible for FREE Shipping offer
