|
I WOULD RATE THIS ON A ONE TO TEN SCALE AS A TEN PLUS. THANKS FOR SUCH A NICE MACHINE. I AM THE PROUD OWNER OF THE JET 12" BANDSAW. THE SQUARENESS OF THE 12" IS ABSOLUTELY WONDERFULL. I WISH THE FENCE WOULD HAVE COME WITH IT, BUT HERE YOU ARE AGAIN. I HAVE OWNED THE NICKEL AND DIME BANDSAWS ALL MY LIFE (I AM 60).
AND NICE I BOUGHT. THE ONLY THING I HAVE TO COMPLAIN ABOUT IS THAT I AM SO SORRY THAT I DIDN'T PURCHASE ONE LONG AGO. IF YOU WANT QUALITY, YOU MUST PAY FOR IT. SUCH A NICE BANDSAW. I GOT TIRED OF USING GARBAGE AND DECIEDED TO FINALLY BUY SOMETHING NICE. I HAVE CUT OAK, ASH AND POPLAR AND I HAVE GOTTEN THE BEST CUTS IN MY LIFE, AS FAR AS BANDSAWS ARE CONCERNED.
REGARDS, TERRY ANYTIME I CAN HIT WITHIN A 1/64 TO 1/128TH OF AN INCH I GO ESTATIC.
Then Amazon tells me "this is a widespread problem", and that I should send the replacement back as well.I just took the loss as a lesson, and went ahead and mounted it to my bandsaw.It's not a bad unit, but just be aware it will not include the accessories. This fence is advertised as including a miter gauge and a resaw adapter. Neither of which is actually included. And they still have not removed the false advertising from the unit's description. Sent it back and received a replacement - same thing, no accessories.
Just take note that the miter gage is not included (but,is pictured in the view). Fence works great. Only problem would be if you want to use the metric scale on the fence guide. I was sort of surprised that it did not come in the box until I looked closer at the description. The pointer covers the metric side of the scale.
Pointer is weak but considering the error in measurement added by the rough cut of the blade itself it is plenty accurate. Needed a good whack with a hammer on the tab that friction locks the near side of the fence. It is just like the Jet contractors saw fence: square adjust with four screws, friction lock on one side only. (.). You can adjust the front rail to line up the measuring tape.
TIP: if you don't already have one buy a feeler gauge or better yet a set of setup blocks. Having to pay over 50$ for such a critical piece of equipment that is standard on most other band saws the least they can do is get the tape on straight and true. But it does work fine just plan on spending additional money on a new adhesive measuring tape and a good set of setup blocks. First of all the fence works fine once you tune it up, the table of the saw is predrilled to accept the rails and their assembly is pretty straight forward. Since there are no other fence systems out there for the Jet your stuck with this one.
The fence itself is not assembled and there are no instructions provided, but its fairly obvious when you look at the CAD drawing on the parts list what goes where. This makes setting the fence height from the table a lot easier. My only gripe is the sick-on ruler that came pre-attached to the rail is not square to table and is full 3/4" off the mark. Easily replaced with another stick on ruler but its a bit annoying that its that far off.
|
May be eligible for FREE Shipping offer
