|
This product for the cost was a steal as the cutting blades are usually around 2.00 dollars each and not a whole container for around 3.00.What a deal and they were not cheap knock offs.They performed excellently.
awesome disks i shaped some transformers logo on a Aluminum shell also cut over steel, but you need some touch to make it right, you must set the speed to max, usually 10/10 then of course use your glasses, then press little by little until you make contact go as slow as you can, don't try to rush because if you do the disk will shorten and you won't be cutting much, if you master the technique you should be able to cut more than 30cm with each disk. good luck with this, great item Yes by the way the Aluminum shell was 1.5mm
I use them with a B&D Wizard to cut stainless steel hardware at maximum speed and if you stay still, it will cut like a hot knife in butter.
|
