|
Nice product. The clamp cannot be used on an tilt angle cut, as they get in the way of the saw tilt. The quick release feature is quite convenient.
The clamp is heavy duty, large and solid. I broke that out using a bolt and a hammer, then it worked great. The first couple of times I tried to install the clamp, it wouldn't fit all the way into the hole. Turns out, there was some slag in the saw from when it was made.
Was unable to use clamp on a lot of angled cuts because it interfered with the saw as it was lowered.
The clamp worked just like a clamp should. The only fault is that it would be nice if it were just a little bit taller so that it would be easier to swing out of the way over the fence without having to move the fence. It is very easy to set up and move to and from either side of the saw.
I set it up on my DW 708. Other than that, It works as advertised It's a simple thing, but it took me a minute to figure it out.
|
